Yahoo奇摩 網頁搜尋

  1. 體味重的原因 相關

    廣告
  2. 過去一個月已有 超過 1 萬 位使用者造訪過 jing-chi.com.tw

    夏天多汗,超困擾!肉毒微整多汗治療,免開刀,恢復快,讓你炎熱夏日不尷尬,重拾人際關係。 少女腋下多汗還飄濃烈狐臭!肉毒微整多汗治療,輕鬆擺脫濕腋下,讓你舉手投足不尷尬,立即預約。

搜尋結果

  1. 3. PROCESS CONDITION. cured at 140deg.C for 20 minutes x 2 cycles. In case no marking ink is applied, solder mask should be cured at. 150deg.C for 60 minutes. 4. ATTENTION IN PROCESS: As to the operation environment. It is desirable to deal with the ink under the yellow lamps in the clean room.

  2. 3. PROCESS CONDITION. cured at 140deg.C for 20 minutes x 2 cycles. In case no marking ink is applied, solder mask should be cured at. 150deg.C for 60 minutes. 4. ATTENTION IN PROCESS: As to the operation environment. It is desirable to deal with the ink under the yellow lamps in the clean room.

    • 152KB
    • 4
  3. FEATURES . PSR-4000 AUS308/CA-40 AUS308 is two component, liquid photoimageable solder resist (alkaline developable type) with following features: . Excellent crack resistance. Electrolytic/Electroless Au/Ni plating resistance. Excellent PCT resistance. Adhesion to Molding compound. SPECIFICATION. *: After mixing. 3. PROCESS CONDITION.

  4. www.taiyo-hd.co.jp › _cms › wp-contentPSR-800 AUS SR1

    2nd chamber Temperature: 80deg.C 60-80deg.C Pressure: 60sec. at 8Kgf/cm2. Exposure. Contact exposure machine. ORC MANUFACTURING CO.,LTD EXP-2960 Luminace: 35mW/cm2 500mJ/cm2 ( on career film) 400-500mJ/cm2 Ambient temp 23.5 +/- 0.5deg.C. Hold time. 10min 10-20min. Development.

  5. FEATURES . PSR-4000 GEC50K1/CA-40 G50 is two component, liquid photoimageable solder resist (alkaline developable type) with following features: . High sensitivity. Excellent electrolytic/electroless Ni/Au resistance. Excellent in water-soluble flux resistance. Non halogen content and low outgas emission. SPECIFICATION. *: After mixing. 3.

  6. 1. Preventing solder from adhering to unnecessary areas. Solder resist prevents solder from adhering to areas other than electrical contacts and thereby causing short circuits when various components are soldered onto a printed circuit board (PCB). 2. Protecting the circuit pattern from dust, heat, and moisture.

  7. R52/53 - Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment. SAFETY PHRASES : S24 - Avoid contact with skin. S36/37 - Wear suitable protective clothing and gloves. S23 - Do not breathe vapour. S46 - If swallowed,seek medical advice immediately and show this.

  1. 其他人也搜尋了